Hi, there - When I lived aboard, I disliked the idea of having a gasoline engine. For those of you who'd like to extend your surface time/range or for battery charging while transiting, there are 6 hp diesel engines going for around $400 to $500 (USD), 2 1/2 centimetre output shaft. Electric start, too, with pull cord as backup. No more ka-boom.
They are out there.
----- Original Message -----
Sent: Wednesday, January 02, 2008 3:57 PM
Subject: [PSUBS-MAILIST] Outbord motor solution.
Frank.
Believe or not - the outboard motor consept was used on UC1 FReya during 2003 and 2004. I used a 5 hk 2 stroke standard long legged outboard to propel Freya out to sea when conditions permittet it. When on position the outborad was taken inbord, and we dived. At 5 Hk she made some 3.5 to 4 knots.
The system suffered from three problems:
1. When i waves higher than 0.5 meters the motor would sometimes get so high up that the propeller got into air, and sekonds later the entire outbord would be submerged. Ultimately this ment that the system was oly function at very nice conditions.
Solution: super long leg, better placement ( eg. a well in the aft part of boat )
2. The engine could not be completely free of gasoline when sotored onboad, causing problem with bad gasoline smell in the small confined space.
Solution: outside container / store on boat
3. People laughed and asked even more stupid questions.
Solution A: Give the Captian of the boat a Luger and some nine milimeter ammo.
Solution B: Explain the consept.
With develupment its not an imposible approch. your boats speed will not be much better with big engine, at 5 meters Freyas chritiacl hull speed was about four knots, and that canot prectically be exceded. A light small engine might be preffered.
Best regards,
Peter Madsen
----- Original Message -----
Sent: Wednesday, January 02, 2008 7:25 PM
Subject: Re: [PSUBS-MAILIST] Size of pusbs.
I have taken a different approach to the surface propulsion problem with my little sub project.
My initial design was to couple the sub with a surface craft like a small pontoon section which would carry a compressor, generator, and outboard motor to power the sub. Now I am adding a motor mount on the back of the sub that can accept a small outboard like maybe 20 horsepower for surface travel. When I get to the dive site, the small outboard will be removed and stored on an accompanying motor boat while the sub goes down, or possibly inside the sub. I have a sketch of the structure for the rear ballast tank and motor mount on frappr. Here's the link to see what it looks like.
I've got the parts for this in the shop and will start fabrication as soon as I finish the hatch hinges and lock-down dogs. Hope to get some pictures of that part up soon. ( Man!!! it takes a lot of grinding to fab these parts.) Frank D.
Jeg beskyttes af den gratis SPAMfighter til privatbrugere.
Den har indtil videre sparet mig for at få 30613 spam-mails
Betalende brugere får ikke denne besked i deres e-mails.
Hent en gratis SPAMfighter her.