[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [PSUBS-MAILIST] Molding lead



Pierre:

See if there is a local blacksmith (phone book yellow pages) with a gas fired forge somewhere near you? I have used automotive tyre lead many times to set hand forged wrought iron hand rails in steps and walk ways using this method. You may have to buy an inexpensive crucible to melt the lead. Once again, look on line for Blacksmithing tools.

You can never beat "heat and beat" technology!

Cheers,

John Gaertner


----- Original Message ----- From: "Marie-Andrée et Pierre" <poulin.carrier@videotron.ca>
To: <personal_submersibles@psubs.org>
Sent: Thursday, April 14, 2005 6:38 PM
Subject: [PSUBS-MAILIST] Molding lead


Hi guys!

I am now the proud owner of about 600 pounds of tire weight (lead) that can't wait to be reshaped into bars for my dead-weight.

Does any of you have a hint on how to easyly melt the lead? I was thinking to use an old BBQ propane oven. The melting point of lead is 635F. The BBQ oven might not be high enough...

I'm open to any suggestions!

Thanks,

Pierre Poulin
Québec Canada.



************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003.  Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.

If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
removeme-personal_submersibles@psubs.org

Removal of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.

PSUBS.ORG
PO Box 311
Weare, NH  03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************







************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003.  Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.

If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
	removeme-personal_submersibles@psubs.org

Removal of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.

PSUBS.ORG
PO Box 311
Weare, NH  03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************