[PSUBS-MAILIST] Molding lead

[Marie-Andrée et Pierre <poulin.carrier@videotron.ca>]

Hi guys!

I am now the proud owner of about 600 pounds of tire weight (lead) that 
can't wait to be reshaped into bars for my dead-weight.

Does any of you have a hint on how to easyly melt the lead? I was thinking 
to use an old BBQ propane oven. The melting point of lead is 635F. The BBQ 
oven might not be high enough...

I'm open to any suggestions!

Thanks,

Pierre Poulin
Québec Canada. 




************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003.  Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.

If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
	removeme-personal_submersibles@psubs.org

Removal of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.

PSUBS.ORG
PO Box 311
Weare, NH  03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************