[Date Prev][Date Next]
[Chronological]
[Thread]
[Top]
Re: [PSUBS-MAILIST] Shark Skin Effect
You are going to laugh, but what about spray on bed-liner?
Is there a reason this won't work? It would give you the correct
finish.
Warren.
> I wonder, instead of rolling it into the surface of the steel... a very
> costly process... could it be attached as an applique... maybe something
> like vinyl glued to the surface? Maybe even an epoxy paint with the
> pattern rolled into it as it dries? Just a thought.
>
> On Mon, 2003-01-13 at 16:21, Garry Muir wrote:
>
> > Hi Folks
> >
> > There was some discussion a while back about sharks skin and the way the
> > denticles produce a laminate flow over it reducing drag. I was looking
> > through some scratch notes I made a few years back on trawl doors and I
> > am quite sure a company tried rolling a pattern on steel plate that
> > would replicate the effect and for some reason I think it may have been
> > NETS of Seattle.
> > I will delve into my files or should I say large confused heap on the
> > floor and get some more info, it may not be a practical finish for a sub
> > hull but it may have some advantages on control surfaces and appendages.
> >
> > Regards, Garry
>
>
> Dale A. Raby
> Editor/Publisher
> The Green Bay Web
> http://www.thegreenbayweb.com
<< dalesignature.gif >>
--
______________________________________________
http://www.linuxmail.org/
Now with POP3/IMAP access for only US$19.95/yr
Powered by Outblaze