Thanks for that. Sorry, i dont think i was clear. I meant on the through hull penetrators that go from the pods into and through the pressure hull. The plans show 2, but i have 3. 2 x electrical penetrators and 1 x vent.Have a look here. http://www.guernseysubmarine.com/Extended_files/Page3524.htmthanksJamesOn 6 September 2010 14:54, Daniel Lance <lanceind@earthlink.net> wrote:
James,A double fillet weld is correct . The battery pods are only being "attached" to the outside and are not a critical pressure boundary weld.Just make sure you have a continuous weld all the way around to avoid any water from infiltrating in between the the flat bar and the pressure hull.Dan Lance----- Original Message -----From: James FranklandSent: 9/6/2010 6:49:48 AMSubject: [PSUBS-MAILIST] Battery Pods WeldHi All,Im going to attach my battery pods this afternoon. The plans show 1/4 inch double fillet as opposed to a full penetration weld. Is that right? What have other people done with those fittings?Its certainly a lot easier to do a double fillet but i just want to make sure its right.ThanksJames