[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [PSUBS-MAILIST] Battery Pods Weld

To: personal_submersibles@psubs.org
Subject: RE: [PSUBS-MAILIST] Battery Pods Weld
From: "Daniel Lance" <lanceind@earthlink.net>
Date: Mon, 6 Sep 2010 09:54:23 -0400
Domainkey-signature: a=rsa-sha1; q=dns; c=nofws; s=dk20050327; d=earthlink.net; b=JXvLtF+ZnkRUM1d+brYEBdVzUJAOsiqjOY2UvAe20PHASLJbaa3MaxmyBjeXM5sX; h=Received:Message-ID:X-Priority:Reply-To:X-Mailer:From:To:Subject:Date:MIME-Version:Content-Type:X-ELNK-Trace:X-Originating-IP;
Reply-to: personal_submersibles@psubs.org
Sender: owner-personal_submersibles@psubs.org

James,

A double fillet weld is correct . The battery pods are only being "attached" to the outside and are not a critical pressure boundary weld.

Just make sure you have a continuous weld all the way around to avoid any water from infiltrating in between the the flat bar and the pressure hull.

Dan Lance

----- Original Message -----

From: James Frankland

To: personal_submersibles@psubs.org;member-forum@psubs.org

Sent: 9/6/2010 6:49:48 AM

Subject: [PSUBS-MAILIST] Battery Pods Weld

Hi All,

Im going to attach my battery pods this afternoon. The plans show 1/4 inch double fillet as opposed to a full penetration weld. Is that right? What have other people done with those fittings?

Its certainly a lot easier to do a double fillet but i just want to make sure its right.

Thanks

James

Prev by Date: [PSUBS-MAILIST] Battery Pods Weld
Next by Date: Re: [PSUBS-MAILIST] well being
Previous by thread: [PSUBS-MAILIST] Battery Pods Weld
Next by thread: Re: [PSUBS-MAILIST] Battery Pods Weld
Index(es):
- Date
- Thread