|
Hi people,
I need to design the reinforcement of the area
around my hatch seat.
I've read that with through hulls a general rule is
you replace as much material as has been removed
at a 1/4 gradiant.
My sub is small & is being made of fiberglass.
At this stage I'm just trying to get in the ballpark with
my design calculations, as I intend to take take my
drawings to a composite engineer & get them
analysed & corrected where
necessary.
Would the reinforcement be better on the inside of
the hull, the outside, or divided evenly on both sides.???
Thanks regards Alan
P.S. To European & South African psubbers.
NewZealand hot favourites for the world cup.
|