[PSUBS-MAILIST] Ribs

["Brian Cox" <ojaivalleybeefarm@dslextreme.com>]

Hi All,   I think a number of people could answer these questions, but I've
been fooling around with the hull calculator and thinking about how I'm
going to do my ribs.  I didn't see any difference beween a 10" spacing and a
12" spacing as far as the ultimate depth rating, I guess maybe it is so
close that it was not a factor.  But the one question I had was, once those
strips are cut out for the small diameter of the T ,  assuming they are
1/4", is it nessesary to roll them or are they flexible enough to tac and
bend into place?   Obviously they would need to be welded up first before
fitting them into place.  Sorry for this repeat question !

Cliff, your hull is a 30" dia correct?  What is the id dia of your hatch ?

Brian





************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003.  Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.

If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
	removeme-personal_submersibles@psubs.org

Removal of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.

PSUBS.ORG
PO Box 53
Weare, NH  03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************