[Date Prev][Date Next] [Chronological] [Thread] [Top]

Re: [PSUBS-MAILIST] hemispherical steel



In their Orange County Metal works, Commercial Metal Forming http://www.commercialmetalforming.com/ocmw.html has the capacity to make just about any kind of head up to 268" in diameter.  The good news is that they can fabricated any odd ball diameter head at a reasonable price. The bad news is they get this flexibility because they are stamped segmented heads, not single stamped heads. What you get from the works are four wedges and one dollar cap that you will have to weld to make up the head.  They also have a limited number of standard sized heads.  They are used to dealing with ASME A516 Grade 70 and 0.5" thickness is no problem.  The last phone number I had for them was 1-800-854-3307.  For a cost point, a 32" by 0.25" A516 Grade 70 hemi was quoted at $428.00 less shipping cost. 
 
Cliff
----- Original Message -----
From: bruno masse
To: Personal_Submersibles@psubs.org
Sent: Tuesday, April 16, 2002 8:35 PM
Subject: [PSUBS-MAILIST] hemispherical steel

ello every one! i,m trying to find hemispherical steel manufactured of a516 grade 70, i need a 38 inch od and 0.50 thick
 
where can i find it? thank you