Re: Welcome Vance

["Marsee Skidmore" <heyred@email.msn.com>]

The first place I start shopping for generic industrial hardware is
www.thomasregister.com. They'll link you straight to web sites and
literature by fax, where available.

Welcome to the bulletin board, Vance. I think I recall doing volunteer work
on your first Kittredge, when I was a baby Engineer doing an internship at
HBOI. I spent a lot of head scratching time to come up with the same prop
diameter as Admiral K.

You might want to tell Dom to ask some pointed questions about the water
absorption properties of Nylon. Certain flavors of Nylon turn to poop with
extended immersion.

:-o Joe
-----Original Message-----
From: VBra676539@aol.com <VBra676539@aol.com>
To: personal_submersibles@psubs.org <personal_submersibles@psubs.org>
Date: Thursday, April 15, 1999 5:30 PM


Speaking of pistons, any idea on resources for 1/4" shaft short
>stroke (3 to 6 inch) single and double acting hyd. pistons.  Not the
pressed
>together units, but the brass rebuildables.
>Regards,
>Vance
>