|
Hi Scot
You will have to make an extra thru hull in line with your
2 breathers depending on where u are going to locate your pods I moved mine 10''
aft . I made a step down sleeve of 316 ss, then I turned some UHMWPE
insulating material to fit the sleeve with 2 O-ring grooves I made sure at
either end I added1.5'' to be able to form a wall between my pos and
neg lugs I also drilled 2 step down 6mm to 10mm holes through the UHMWPE
which I turned to fit copper rods also with 2 O-rings. On either side I cut
thread and fitted copper washes and brass nuts on both ends.The narrower bores
are all on the pressure hull side incase of an explosion in the B Pods.I also
plan on fitting fuses inside the pods.
I used a aluminum tool to lathe the UHMWPE it worked great
.O ja to cut my inner O ring grooves I silver solded a parting tool tip to the
end of a piece of key steel it also worked great .
I have tried to stick as much as possible to the K350's
plans as its really been well thought out.
If you give me your e mail I can send you
pics.
All the best
Glen
|