From: Jon Wallace <jonw@psubs.org>
To: personal_submersibles@psubs.org
Sent: Mon, November 2, 2009 3:45:31 PM
Subject: Re: [PSUBS-MAILIST] Re: Stiffiners on Heads
Cliff,
Curious about your comment here since it looks like with a beveled edge on the stiffener and a full penetration weld this should not be too difficult. Can you give more context on any fabrication problems one might run into?
Jon
Cliff Redus wrote:
>
>
>
> As to parallel circumferential
stiffeners, I did not try this. For sure they would work better than radial but I did not try them in my FEA analysis so I can't comment on their effectiveness or lack thereof. It would not be easy to fabricate this type of inner stiffener.
>
************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003. Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.
If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
removeme-personal_submersibles@psubs.orgRemoval of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.
PSUBS.ORGPO Box 53
Weare, NH 03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************