Re: [PSUBS-MAILIST] Re: Stiffiners on Heads

[Jon Wallace <jonw@psubs.org>]

Cliff,

Curious about your comment here since it looks like with a beveled edge 
on the stiffener and a full penetration weld this should not be too 
difficult.  Can you give more context on any fabrication problems one 
might run into?

Jon



Cliff Redus wrote:
> As to parallel circumferential stiffeners, I did not try this.  For 
> sure they would work better than radial but I did not try them in my 
> FEA analysis so I can't comment on their effectiveness or lack 
> thereof.  It would not be easy to fabricate this type of inner stiffener.




************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003.  Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.

If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
	removeme-personal_submersibles@psubs.org

Removal of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.

PSUBS.ORG
PO Box 53
Weare, NH  03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************