|
Howdy Frank,
Cool, sounds like we are at the same stage on some thing. I'm
just about ready to put a couple coats of gel coat on my FRP MBT's that I'll be
using for plug molds. Are you using laminating gel coat polyester
resin? One trick I've learn from some old pros is to apply a
coat of PVA mold release or baby powder to filler, and other resin coats after
they kick for a bit. This allows them to cure out much better, so
you don't gum up you sandpaper later. It works wonders on Bondo. Then after 24
to 48 hours (the longer the better). You just wash the PVA or baby powder off
and sand the way you want to. You can spray the PVA on if you
wish.
Brent
From: ShellyDalg@aol.com
Sent: Tuesday, August 25, 2009 11:04 PM
Subject: Re: [PSUBS-MAILIST]
Antipodes/XPC15/PC-1501 Hi Brent. I've enjoyed the Seamagine web site.
Testing will prove if my controls design will be
usable.
The box will be fairly small ( hoping for 4"X 6" )with just 4 speed
dials and three rocker switches. I'm hoping it will be fairly easy to manipulate
the controls using just the two types...dial and switch.
The speed control dials will usually be just set at a given speed, unless
precise positioning is needed. Each dial has forward/reverse with the control
circuit providing the step down.
Each of the 4 motors have their own dial so sharp turns or spinning on axis
should be possible.
The three rocker switches controlling dive planes and rudders should be
fairly easy. Not quite as natural as a steering wheel, or maybe a joy stick, but
very compact and requires just a finger to steer left right or set dive plane
angle. The momentary switch and electrical linear actuators act to maintain the
position until the rocker switch is pressed again.
I haven't figured out yet how I will monitor the actual rudder and dive
plane position relative to "center" but I think some actuators have a
potentiometer built in that could send a position signal. Just gotta figure out
how to interpret that signal into a display that's simple to maintain and easy
to read.
Put another color coat on the back fairing today. Startin' to get real
shiny!
Frank D.
|