Re: [PSUBS-MAILIST] Minn Kota V Motor Guide

[djackson99@aol.com]

It tis a shame, because they are made right here in Tulsa.  I've even been over and talked to the guys and the factory.

 But check this out; Lenco uses MotorGuide motors for this system:
http://www.youtube.com/watch?v=w6xfglrow6A

If you replaced the shaft seals with better quality lip seals you would have an off-the-shelf dual thruster control system including dive plan controls.

Best of Luck
Doug
SubmarineBoat.com

-----Original Message-----
From: James Frankland <james@guernseysubmarine.com>
To: personal_submersibles@psubs.org
Sent: Thu, Jun 18, 2009 9:18 am
Subject: Re: [PSUBS-MAILIST] Minn Kota V Motor Guide

Doug



I called them and your right.  Im going with the Minn Kota, thanks.



Also, good pics on your website, id not seen those before, very usefull.



Regards

James





----- Original Message -----

From: djackson99@aol.com [mailto:djackson99@aol.com]

To: personal_submersibles@psubs.org

Sent: Wed, 17 Jun 2009 19:07:51 -0400

Subject: Re: [PSUBS-MAILIST] Minn Kota V Motor Guide



Motor Guide's have the electronics in the head, so don't go with them if you 

plan to pressure compensate them. 



I have details of my 2 thruster controller on my web site.



Best of Luck

Doug J

SubmarineBoat.com