I would TIG it, less distortion and better results, but put lots of tack on
it to minimize distortion and keep it from opening up too much.
----- Original Message -----
Sent: Thursday, February 26, 2009 2:59
AM
Subject: [PSUBS-MAILIST] welding sheet
metal
Frank and or all you welding guru's
Any tips on welding sheet metal. I have my saddle tanks formed
and I am
going to weld two pieces together.
In my past experience I have found it difficult. Pourous welds
etc.
One thought I had was to weld em for strength and then Braze over
the
top.
I will be welding 18 gauge cold rolled with a
MIG
Dean
Get a jump start on your taxes. Find
a tax professional in your neighborhood today.