|
Brent & Vance, Thanks for taking the lead with the illustration of a MBT
valve. I have taken the liberty to play with the design some, see the 3
images at http://flickr.com/photos/bottomgun
in the MBT Vent Valve group. I believe if you have a FLICKR account, you
can view the images at a higher resolution. Some thoughts: 1.
Want to minimize number of moving parts 2.
Want to minimize the number of hinge points 3.
Want to mount the complete valve assembly on the tank
surface so that if there is give between the hull and the tank surface, closing
tolerances and alignment will not be affected. 4.
Want seating surfaces to mate square on to insure
complete closing of valve 5.
Seating surface material should be above the valve disk
so sand or other matter doesn’t settle on it and allow air to leak 6.
Seating material should be a soft elastic material 7.
Operating cylinder should fail in the valve closed
position (some cylinders have springs installed and air pressure operates
against the spring below the piston, not sure if Bimba has this capability) Bimba cylinders, 3-D models in various formats are available
on their web site: R/Jay Respectfully, Jay K. Jeffries Andros Is., Bahamas As scarce as the truth is, the supply has always been in excess of
the demand. -Josh Billings |