You know I have been looking at Beer Kegs (I
have a Few) and they have an opening at one end that can have 2 valves welded
onto it quite easy and that are stainless... Most that I have say they have a
50BAR test pressure...! That is huge... No rust and not hard at all to convince
your local Pub to donate you one...!
Hi James. Yes, The cost of those "lite" tanks seems quite low to me. No
way could I build a tank for that and have the connections and all. Because my
tank is inside the hull, I like the idea of being able to see the water level.
The idea is to be able to add water to a pre-determined level while at the
surface depending on what buoyancy is needed. Small adjustments can be made
while still shallow so no really high pressure would be required. If I needed
a little adjustment at depth though, the tank can still take it. I can see the
water level, and add a half gallon or remove a half gallon. ( that takes a
pump )
If the tank was outside the hull, I think I'd
probably go with a stainless one. I saw some SS pipe at the
recycle yard and a two foot piece of 1/4 " X 10" was about $80. End cap
plate, and fittings would likely add another $100 or so. A little pricey but
not out of reach.
Frank D.
Gas prices getting you down? Search AOL Autos for fuel-efficient used
cars.
##########################################################
Important Notice:
This message and its
attachments are confidential and may contain information which is protected by
copyright. It is intended solely for the named addressee. If you are not the
authorised recipient (or responsible for delivery of the message to the
authorised recipient), you must not use, disclose, print, copy or deliver this
message or its attachments to anyone. If you receive this email in error, please
contact the sender immediately and permanently delete this message and its
attachments from your system. Any content of this message and its
attachments that does not relate to the official business of Seven Network
Limited or its subsidiaries must be taken not to have been sent or endorsed
by any of them. No representation is made that this email or its attachments are
without defect or that the contents express views other than those of the
sender.
##########################################################
|