|
Vance,
Like Alec said, It's two inch channel on the
prints.
I used urethane to seal the fiberglass
shell to the hull and a stainless steel strap cinched down over
that. I used stainless steel bolts to attach the fiberglass to the
channel support frame. No flex at all!
Dan H.
----- Original Message -----
Sent: Wednesday, May 14, 2008 3:21
PM
Subject: [PSUBS-MAILIST] Kittredge MBT
question
Dan H and all,
Captain George has 4" channel on his
prints for the main ballast tank supports. Seems a might excessive to me. Did
you cut this down? It seems like I remember a tripod support on Patience. Yes,
no? What size material did you use? I'm rebuilding this one, and the old stuff
is long gone, but it looks like 2" was used, originally, also three legged. Do
you think that will take enough flex out? And I'm not using the honking big
aft thruster this time, so won't need to support that extra tonnage in back.
I'm going to build a bottom to the tank that will tie into the shells I have,
then wrap around the structual steel and extend downward in the middle--not
quite like yours, but similar. The idea being to get this thing done with and
in the water, of course.
Vance
|