Hi again Randy,
Personally I think that this dual shield method is ideal be cause you get
most of the speed of the mig and most of the benefits of stick. It is the method
that I am using. Because wire is much less dense than a stick it is very
important to weld steel preheated to about 200 degrees for best results,
especially in heavier sections to assure good penetration. I got the 200 deghree
figure from Dan Lance who really is our welding guru and the expert in this
area.
I do know that Dan prefers stick welding from conversations with him.
Best Regards,
Jim K
----- Original Message -----
|