|
I also have a light weight lathe with a babbet head stock, what i found to
work for me was to cut the tool bit with a high rake about 35' this allowed me
to make .050 deep cuts in 304 ss with good results also the tooling was set
slitely above the c/l try it and see if it works for you
In a message dated 3/25/2008 12:04:51 P.M. Eastern Daylight Time,
james@guernseysubmarine.com writes:
Hey
Frank.
> I don't know anything about machining, but that's a great
job on building a
> web site. Frank D.
Thanks!
Unfortunately it takes over half an hour to update it now as i have to
recompile the whole thing and upload it all. Luckily i can do it while
im at work ;)
Right, im off to try Dan and Jims ideas for the
lathe.
James
----- Original Message -----
From:
ShellyDalg@aol.com [mailto:ShellyDalg@aol.com]
To:
personal_submersibles@psubs.org
Sent: Tue, 25 Mar 2008 10:37:46
EDT
Subject: Re: [PSUBS-MAILIST] Lathe Problems
In a message
dated 3/25/2008 3:29:19 A.M. Pacific Daylight Time,
james@guernseysubmarine.com
writes:
http://guernseysubmarine.wordpress.com/
I don't know
anything about machining, but that's a great job on building a
web
site. Frank D.
**************Create a Home Theater Like the
Pros. Watch the video on AOL
Home.
(http://home.aol.com/diy/home-improvement-eric-stromer?video=15?ncid=aolhom00030000000001)
|