[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[PSUBS-MAILIST] Rotary Table for Drilling View Ports and the Like

To: PSUBSorg <personal_submersibles@psubs.org>
Subject: [PSUBS-MAILIST] Rotary Table for Drilling View Ports and the Like
From: Brent Hartwig <brenthartwig@hotmail.com>
Date: Sat, 23 Feb 2008 02:20:42 -0800
Importance: Normal
Reply-to: personal_submersibles@psubs.org
Sender: owner-personal_submersibles@psubs.org

James,

It looks like you could of used a rotary table on your drill press like this one I'm planning on acquiring, to make the drilling of your viewports a lot easier.

http://www.grizzly.com/products/g9299

I'm also considering aquiring this XY Cross table for my drill press, until I can upgrade to a large Mill/Drill.

http://www.grizzly.com/products/h7659

Regards,
Brent Hartwig

Follow-Ups:
- RE: [PSUBS-MAILIST] Rotary Table for Drilling View Ports and the Like
  - From: "Brian Cox" <ojaivalleybeefarm@dslextreme.com>

Prev by Date: RE: [PSUBS-MAILIST] Coved O-ring Groove
Next by Date: Re: [PSUBS-MAILIST] Page 9..
Previous by thread: Re: [PSUBS-MAILIST] sub plans
Next by thread: RE: [PSUBS-MAILIST] Rotary Table for Drilling View Ports and the Like
Index(es):
- Date
- Thread