Re: [PSUBS-MAILIST] Hull failure calculation sheet

[dinosnider666@spacemail.com]

If you get a mill cert with your pipe, it
> would be OK.  To have the piece of pipe you select further inspected would
> be reasonably cheap if you so desired, though I would rely on a pressure
> test as it would be free.
>--
Many thanks, mr. barlow. (I nearly deleted your e-mail before reading it, looking at the company name-  you must get that a lot! Aside- Regal car to be renamed LaCrosse - but not in Quebec, where what it refers to will make you go blind, according to myth...)

I saw some ?x70 being made in Australia. Any x80 out there in c. 26". Also, what thicknesses are available. I'm thinking heavy front, thin rear - let extra struts/pressure do the work.Pretty ass-heavy right now.
D 
> 
>