[Date Prev][Date Next]
[Chronological]
[Thread]
[Top]
RE: [PSUBS-MAILIST] Acrylic and Plexiglass
I'm interested in getting a copy if they become available.
Roger June
REJ and Company
rjune@fuse.net
513-300-1189
> -----Original Message-----
> From: owner-personal_submersibles@psubs.org
> [mailto:owner-personal_submersibles@psubs.org]On Behalf Of Mark Steed
> Sent: Saturday, January 11, 2003 18:04
> To: personal_submersibles@psubs.org
> Subject: [PSUBS-MAILIST] Acrylic and Plexiglass
>
>
> Greetings all. Success. I have found my missing ROHM&HAAS factory
> technical reports on plexiglas design and fabrication. There are
> 9 of them, all under the heading Of: "PLEXIGLAS DESIGN &
> FABRICATION DATA". The report titles are as follows:
> 1.PL1M-GENERAL INFORMATION
> 2.PL2i-CUTTING PLEXIGLAS ACRYLIC SHEET
> 3.PL3j-MACHINING PLEXIGLAS BRAND ACRYLIC SHEET
> 4.PL4K-FORMING PLEXIGLAS SHEET (The really good one)
> 5.PL8j-PLEXIGLAS SHEET MAINTENANCE
> 6.PL9g-PLEXIGLAS SHEET FINISHING
> 7.PL10i-PLEXIGLAS SHEET ANNEALING
> 8.PL52L-PAINTING PLEXIGLAS CAST ACRYLIC SHEET
> 9.PL-612d-ULTRAVIOLET FILTERING AND TRANSMITTING FORMULATIONS OF
> OF PLEXIGLAS ACRYLIC SHEET
>
> Everything is here-all the techniques and methods of making just
> about anything with plexiglas acrylic. There is a wealth of
> material complete with specifications, charts, tables,
> illustrations, photographs and methods where a person could build
> one helluva an acrylic fabrication set-up. Heating system design
> and construction, mold techniques and materials, clamps and
> rings, tool design, time and temperature charts, air pressure and
> techniques,and much more is covered. All combined, there are
> approximately 80 pages. These reports are copyrighted by
> ROHM&HAAS all around 1979. I have not checked for a factory
> website or ran any searches to see if any of this is on line by
> them. I would like to make all of them available to the entire
> group. I suppose they could be scanned or even photocopied easy
> enough but I do not want to get in the middle of a copyright
> infringement mess. If there is any interest, I will figure
> something out. Anybody have any ROHM&HAAS contacts? Ray, what do !
> you think? Regards, Mark Steed
>
>
>