[PSUBS-MAILIST] OTS comms sources

[David Colombo via Personal_Submersibles]

Sean, I'm not sure. My understanding was that they were just replacing the
equipment due to age. Interesting question though.
Best Regards,
David Colombo

804 College Ave
Santa Rosa, CA. 95404
(707) 536-1424
www.SeaQuestor.com



On Thu, Oct 15, 2020 at 12:01 PM Sean T. Stevenson via
Personal_Submersibles <personal_submersibles at psubs.org> wrote:

> I'm curious to know what that sherrif's team was upgrading to. Going
> hardwire? Or a different ultrasonic?
>
> Sean
>
> -------- Original Message --------
> On Oct. 15, 2020, 12:37, David Colombo via Personal_Submersibles <
> personal_submersibles at psubs.org> wrote:
>
>
> Sean, I purchased all of my units on Ebay as well. The source for my
> topside base unit, diver unit, and (6) headsets all were from a sheriff's
> office that was updating all of their diver gear. Most of the headsets
> looked like they had never been used, and the base and diver unit had very
> little wear. So outside of Ebay, local law enforcement who have diver
> recovery teams might be a resource before they hit ebay. It would require a
> little bit of leg work, but if units are planned to be replaced it could be
> a resource for the psubs community.
>
>
> Best Regards,
> David Colombo
>
> 804 College Ave
> Santa Rosa, CA. 95404
> (707) 536-1424
> www.SeaQuestor.com
>
>
>
> On Thu, Oct 15, 2020 at 11:07 AM Jon Wallace via Personal_Submersibles <
> personal_submersibles at psubs.org> wrote:
>
>> I can comment that unless you are on a stable dock the "surface" unit can
>> be unwieldy.  It also is not waterproof.  We used Cliff's surface unit in a
>> small dingy at Lake Tahoe and I found it difficult to handle the particular
>> day I was manning it.  Waves were 4-6 feet (very windy that day) and lots
>> of spray coming over the dingy.  The surface unit is bulky under those
>> conditions, I had to keep the surface cover closed to keep it from getting
>> too wet which was a pain when necessary to adjust the volume/squelch.  I
>> found it was just a lot to handle under those conditions.
>>
>> I've got both a surface unit and SSB2010, but for the reasons stated I am
>> planning on using the surface unit within the sub; the SSB2010 at the
>> surface.
>>
>> Jon
>>
>> On Thursday, October 15, 2020, 01:10:20 PM EDT, Sean T. Stevenson via
>> Personal_Submersibles <personal_submersibles at psubs.org> wrote:
>>
>>
>> I might actually consider purchasing two SSB-2010 units, as these can be
>> used as a surface unit as well with the addition of a CDK-6 kit. Not quite
>> as feature rich as a dedicated surface unit, but might be a good choice
>> owing to the flexibility to reconfigure for diver-diver or diver-surface.
>>
>> Sean
>>
>>
>> _______________________________________________
>> Personal_Submersibles mailing list
>> Personal_Submersibles at psubs.org
>> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>>
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20201015/f32ae57c/attachment.html>