[PSUBS-MAILIST] threw hull fitting

[Rick Patton via Personal_Submersibles]

Sorry for the confusion Vance. Should have worded it differently I guess.
The strain relief fitting would screw into the machined stainless steel
plug that is welded into the hull. What did you use in your sub to pass
wires threw?

Rick

On Sat, Jun 6, 2020 at 3:04 AM via Personal_Submersibles <
personal_submersibles at psubs.org> wrote:

> Threw hull fitting? You threw your hull fitting? I'm confused.
> Vance
>
>
> -----Original Message-----
> From: Rick Patton via Personal_Submersibles <
> personal_submersibles at psubs.org>
> To: psubs chat room <personal_submersibles at psubs.org>
> Sent: Fri, Jun 5, 2020 7:18 pm
> Subject: [PSUBS-MAILIST] threw hull fitting
>
> I contacted Sealcon about their wire stainless steel thru hull fitting and
> the ones they had were only rated for 150 PSIG which isn't enough for my
> 350. What are some other sources out there that can take a 300 PSIG
> pressure?
> Thanks
>
> Rick
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20200606/dae09673/attachment.html>