[PSUBS-MAILIST] Drill Sharpening
hank pronk via Personal_Submersibles
personal_submersibles at psubs.org
Mon Sep 3 06:35:37 EDT 2018
Jon,That looks like you can haul a load, very nice. I like how you cut up I-Beam to make your gussets. Are you cutting all that aluminum with your mitre saw? Hank On Sunday, September 2, 2018, 9:01:38 PM MDT, Jon Wallace via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
Hank, I did (see photo attached), although I have one more gusset connection to fabricate tomorrow. Thirty feet of 6061 Aluminum 4x6 I-beam cut into six-foot length cross members. Cross members are 15.5 inches on center and the K-600 sits across the three center cross members. All that silver flaky stuff on the asphalt...that's not a worn out driveway, that's about a billion pounds of drill shavings.
I hope to get the sub back on the trailer tomorrow and then will probably dismantle the gantry sometime this month, in preparation for winter. That has been an extremely handy tool.
Jon
From: hank pronk via Personal_Submersibles <personal_submersibles at psubs.org>
To: Jon Wallace via Personal_Submersibles <personal_submersibles at psubs.org>
Sent: Sunday, September 2, 2018 9:10 PM
Subject: Re: [PSUBS-MAILIST] Drill Sharpening
Jon,Did you get your new cross members in? Hank On Sunday, September 2, 2018, 5:04:25 PM MDT, Jon Wallace via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20180903/aedd138b/attachment-0003.html>
More information about the Personal_Submersibles
mailing list