[PSUBS-MAILIST] Tube Bending Tips/Advice

[Steve McQueen via Personal_Submersibles]

1/4" (19 MM OD).  For now it is the LP O2. Yes the bender is for this size range.
Thanks,
Steve

---- emile via Personal_Submersibles <personal_submersibles at psubs.org> wrote: 
> Hi Steve,
> 
> What is the diameter? HP Lines of 6 or 10 mm? 
> Best is to use a bending tool for the specific diameter.
> 
> Br, Emile
> 
> -----Oorspronkelijk bericht-----
> Van: Personal_Submersibles [mailto:personal_submersibles-bounces at psubs.org]
> Namens Steve McQueen via Personal_Submersibles
> Verzonden: vrijdag 9 maart 2018 16:33
> Aan: Personal Submersibles General Discussion
> Onderwerp: [PSUBS-MAILIST] Tube Bending Tips/Advice
> 
> Getting ready to take some very straight SS tubing and bend it for
> installation.  Never bent tubing before but I have a small hand bender and
> an idea. I was thinking on using something rigid but something I could
> form/bend by hand (heavy wire?) and make a template to then bend the final
> piece against.
> 
> Looking for advice form those who have done this.
> 
> Thanks,
> Steve
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
> 
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles