[PSUBS-MAILIST] Alec's test

[james cottrell via Personal_Submersibles]

Did anyone hear how Alec's test went today?

      From: Alan via Personal_Submersibles <personal_submersibles at psubs.org>
 To: Personal Submersibles General Discussion <personal_submersibles at psubs.org> 
 Sent: Thursday, April 13, 2017 9:34 PM
 Subject: Re: [PSUBS-MAILIST] Oil Compensator
   
Jon,an easy solution is to take the thruster, or that section of the thrusterin to a plumbing merchant or hydraulic repair shop & ask for something compatible with a barbed hose fitting. Sometimes a metric option willfit in an imperial thread, & so they may know of not so obvious solutions.Alan

Sent from my iPad
On 14/04/2017, at 12:53 PM, Jon Wallace via Personal_Submersibles <personal_submersibles at psubs.org> wrote:


Hi Hank,
No, I don't have the shaft, I purchased just the lower head.  A 36 inch shaft is $28 but like you said, I really only need a few inches of it so don't really want to purchase it that way.
Jon 

    On Thursday, April 13, 2017 8:27 PM, hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
 

 Jon, Do you have the shaft that used to screw into the motor?  if so, you can cut it down to a couple inches long and put a waterline compression fitting on that.   Then reduce from the compression pipe thread.  Or you can thread the inside of that stub shaft with a pipe tap and reduce from that, providing it is the heave fibreglass shaft.Hank 

   

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles


   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20170414/e0b28200/attachment-0001.html>