[PSUBS-MAILIST] penetrator

[Alec Smyth via Personal_Submersibles]

Hi Brian,

If these are power penetrators and memory serves, ABS stipulates that each
pole should go through a separate penetrator rather than separate
conductors within the same one.


Best,

Alec

On Fri, Dec 16, 2016 at 7:49 PM, Brian Cox via Personal_Submersibles <
personal_submersibles at psubs.org> wrote:

> Hank,   Starting to work on my electrical penetrators for my motor
> pods .   I need to run 4  - 1/4"  copper threaded rods thru a penetrator
> what kind of separation between them is adequate ?  or should I break it up
> into two penetrators?
>
> Brian
>
> --- personal_submersibles at psubs.org wrote:
>
> From: hank pronk via Personal_Submersibles <personal_submersibles at psubs.
> org>
> To: Personal Submersibles General Discussion <personal_submersibles at psubs.
> org>
> Subject: [PSUBS-MAILIST] penetrator
> Date: Fri, 16 Dec 2016 23:01:23 +0000 (UTC)
>
> Hi All,
> I am looking for a penetrator supplier,  I am hoping to find male ends for
> some penetrators I have.
>
>
> Hank
> _______________________________________________ Personal_Submersibles
> mailing list Personal_Submersibles at psubs.org
> <http:///eonapps/ft/wm/page/compose?send_to=Personal_Submersibles%40psubs.org>
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20161216/9345fe38/attachment.html>