[PSUBS-MAILIST] Zinc coating

[Brian Cox via Personal_Submersibles]

Hank,  Just bought a big compressor yesterday !

Brian

--- personal_submersibles at psubs.org wrote:

From: hank pronk via Personal_Submersibles <personal_submersibles at psubs.org>
To: Personal Submersibles General Discussion <personal_submersibles at psubs.org>
Subject: Re: [PSUBS-MAILIST] Zinc coating
Date: Fri, 1 May 2015 03:50:54 -0700

Brian,
It seems to me that the amount of effort needed to protect your hull with paint is a function of how you use it.  If it sits in a boat slip year round you would need a very serious paint system.  If your going to just dip it in the water once in a while then how important is it.  I am in fresh water only, so I painted Gamma with hardware store rust paint.  Also, there is no such thing as going for a dive and returning scratch free. Gamma needs a touch up after every dive (almost). I would spend the money on a compressor and sand blaster and do it myself, don't paint anything until your welding is finished.  You can also minimize the rust potential with a good design.  Make sure you have no areas that are impossible to paint. I would say if your doing any type of paint system, you should worry about compatibility. Do like Alan says and go to your favorite boat guys and ask what system they like best. Paint system opinions are like Ford versus Chev and air
 compensating verses oil filling :-)
Hank

--------------------------------------------
On Thu, 4/30/15, Brian Cox via Personal_Submersibles <personal_submersibles at psubs.org> wrote:

 Subject: [PSUBS-MAILIST] Zinc coating
 To: "PSubs" <personal_submersibles at psubs.org>
 Received: Thursday, April 30, 2015, 9:25 PM
 
 All, Ok,
 I was going to take my pressure hull ( it's finished ,
 BTW) down and have an outfit zinc coat it but now I'm
 thinking that I should spend that money on a heavy duty air
 compressor and a sand blaster and do it myself.  Since
 I'm sure I will need to be recoating places where
 I'm doing thru hulls and such.  But my question is
 do I need to worry about the compatibility between the zinc
 coating and the epoxy that will on over the zinc
 ??   Should I put the zinc on the inside too
 ?   Are there different types of zinc
 coatings?  
  Brian
 
 -----Inline Attachment Follows-----
 
 _______________________________________________
 Personal_Submersibles mailing list
 Personal_Submersibles at psubs.org
 http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
 

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles