[PSUBS-MAILIST] Fw: deep diver port frame

hank pronk via Personal_Submersibles personal_submersibles at psubs.org
Tue Dec 8 06:11:01 EST 2015


Hello All,Here is my first port frame for my deep diver.  The machining has gone well up to this point-the outer edge is to hard to machine from being flame cut.  I managed to machine the front half of the edge but can't go further.  I could leave it but there is 40 lb of steel I want to get rid of-it still weighs 130lbs.  I think I will take them to a shop a couple hr away and have the outer edge cut off with a water jet. Then I can finish the edge up.  The port inside opening looks real thick but that is just a ring tacked on the inside for the lathe chuck to grab.  I am machining the conical hatch land now and it has nice soft edges so far.My home made power feed is working great even though the speed control is not working.  I control the speed by using a 6v battery instead of 24v.
Hank     On Tuesday, December 8, 2015 3:52 AM, xxx xxxxx <mp13 at live.ca> wrote:
 

  


  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20151208/56b76cae/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_0245.jpeg
Type: image/jpeg
Size: 15461 bytes
Desc: not available
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20151208/56b76cae/attachment-0001.jpeg>


More information about the Personal_Submersibles mailing list