[PSUBS-MAILIST] Fw:

[Daniel Lance via Personal_Submersibles]

Hank,
Cut the 3/8"s thick coupons 5/8"s of an inch wide then turn them on their
side when you bend them . Cut at least two coupons ( statistical average)
for each weld position that you find yourself working in , ie flat ,
vertical , horizontal or overhead. The coupon in your picture is too wide
to be adequately stressed enough to show any deficiencies . Also a "face"
bend like that just isn't a rigorous enough test. That position is usually
used for welding school newbies to "build" confidence .
Dan Lance
On Aug 19, 2015 7:24 PM, "hank pronk via Personal_Submersibles" <
personal_submersibles at psubs.org> wrote:

> Dan,
> This is as far as I can bend it with an 8 ton jack, my sample is a bit
> wider than it should be.  So far so good though.
> Hank
>
> On Wednesday, August 19, 2015 5:17 PM, xxx xxxxx <mp13 at live.ca> wrote:
>
>
>
>
>
>
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20150820/87f8ff1d/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_0126.jpeg
Type: image/jpeg
Size: 16719 bytes
Desc: not available
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20150820/87f8ff1d/attachment.jpeg>