[PSUBS-MAILIST] G.L. summary Pressure Hull

[hank pronk]

Dan,
Thank you, I will play around with it.  I guess that's how we learn.
Hank



On Thursday, December 12, 2013 9:48:21 AM, Dan H. <jumachine at comcast.net> wrote:
  
If you don't have a taper attachment, use the 
compound slide on the lathe.  It's tricky to set since your working on 
fractions of a degree for a good fit but you fine tune it with a few trial 
pieces.   
  
Dan H. 
----- Original Message -----  
>From: hank  pronk  
>To: Personal Submersibles General  Discussion  
>Sent: Thursday, December 12, 2013 10:16  AM 
>Subject: Re: [PSUBS-MAILIST] G.L. summary  Pressure Hull 
>
> 
>Does anyone have a trick to machining an inside taper without lathe   attachments.  I need to make a hub to fit a tapered  shaft.  I made one by trial and error and it will work but it is not  perfect.  
>Hank  
>
>
>
>On Thursday, December 12, 2013 7:13:39  AM, Jon Wallace <jonw at psubs.org>  wrote:
> 
>
>I should have stated up 
  front that we were just having some fun and I hope nobody concentrating on 
  ROV/AUV development and operation takes offense.  PSUBS welcomes ROV and 
  AUV discussions here as well.
>
>Jon
>
>
>
>On 12/11/2013 9:57 PM, Alan James wrote:
> 
>Thanks Keith, 
>>hope  didn't see the phone sex & ROV comments 
>>earlier  
>>Keith  owns a ROV company. 
>>Alan
>>
>
>
>_______________________________________________
>Personal_Submersibles mailing list
>Personal_Submersibles at psubs.org
>http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
>
> 
>
>________________________________
>
_______________________________________________
>Personal_Submersibles 
  mailing 
  list
>Personal_Submersibles at psubs.org
>http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20131212/2e01dc5f/attachment-0001.html>