[Date Prev][Date Next] [Chronological] [Thread] [Top]

Re: pressure hull design (Fwd)



On Sun, 20 Sep 1998 00:18:34 -0600, Bill Vandella <skylar@ccinet.ab.ca>
wrote:

> if you took an apple and cut it in half, then half again, you
> would have 4 identical pieces looking like the smile of a cheshire cat
> if you turned it sideways... take the hull, and cut the right curves out
> of the side, so from the side, it looked like a big fish with its mouth
> open, then weld the two together...

I understand. 

You basically want to take a 90 degree section from each side of a piece of
the pipe. When you're done, from the side, it will look like an elongated
hemisphere, and from the top, it will look like a wedge.

If you think about it from the top, it's easier.

-----------
   \**/
    \/           Pieces cut
    /\
   /**\
-----------

You're going to cut a "X" through the pipe, where the segments of the X are
at 90 degrees to each other. You will use the sections marked in the above
diagram with **.

Is that correct?

Later,
Jon

--------------------------------------------------------------
   Jon Hylands      Jon@huv.com      http://www.huv.com/jon

  Project: Micro Seeker (Micro Autonomous Underwater Vehicle)
           http://www.huv.com