[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [PSUBS-MAILIST] O ring groves



Call your o-ring supplier and give them the dimensions. They will sort it out.



-----Original Message-----
From: Alan James <alanjames@xtra.co.nz>
To: personal_submersibles@psubs.org
Sent: Tue, Aug 17, 2010 4:29 am
Subject: [PSUBS-MAILIST] O ring groves

Hi submarine experts,
I'm looking at hatch O rings & groves.
I see that on the K250 hatch plan the o ring grove is dovetailed on the inner edge.
Is this done on the K350?
I think I can remember hearing advice to buy an O ring slightly smaller than the
grove diameter so that it is held up against this dove tailed edge. I've been reading
that the dove tail grove is not recommended & that the O ring should start off central in the grove.
Also I've seen some hatches with the O ring grove in the lower (conning tower)
side hatch face.
Has anybody got any thoughts / words of wisdom on this thanks.
Regards Alan