[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [PSUBS-MAILIST] blue print problems

To: personal_submersibles@psubs.org
Subject: RE: [PSUBS-MAILIST] blue print problems
From: "Daniel Lance" <lanceind@earthlink.net>
Date: Sat, 24 Jul 2010 13:16:54 -0400
Domainkey-signature: a=rsa-sha1; q=dns; c=nofws; s=dk20050327; d=earthlink.net; b=A93YpJmPIMT2Y+xpO+QNU5SfGibsj2yxiC2/2pJBb6V4uyhyPntLLN/YsamvCtH8; h=Received:Message-ID:X-Priority:Reply-To:X-Mailer:From:To:Subject:Date:MIME-Version:Content-Type:X-ELNK-Trace:X-Originating-IP;
Reply-to: personal_submersibles@psubs.org
Sender: owner-personal_submersibles@psubs.org

And by all means go with the XXh since you are cutting a 2 3/8 " diameter hole in the 3/8" thick elliptical head.

----- Original Message -----

From: Scott Waters

To: psubs

Sent: 7/24/2010 11:55:30 AM

Subject: [PSUBS-MAILIST] blue print problems

I have a confuseing issue with the K-350 blueprints. On blueprint number 4 the cabin flood nipple it says 2"x3" XXH pipe nipple, but blueprint number 13 says is a 2"x4" sched 80. I am confuesd what I need to use for the cabin flood nipple. I think the sched 80 will work just fine, but maby there is something I am overlooking. Anyone know what needs to be used?

Thanks,
Scott Waters

The New Busy is not the old busy. Search, chat and e-mail from your inbox. Get started.

Prev by Date: RE: [PSUBS-MAILIST] blue print problems
Next by Date: Re: [PSUBS-MAILIST] linear actuator- thruster range
Previous by thread: RE: [PSUBS-MAILIST] blue print problems
Next by thread: [PSUBS-MAILIST] Nekton Gamma
Index(es):
- Date
- Thread