|
Dean, I would not braze; its
twice the work and heat input. A good mig weld is not
porous. A lot of welding mishap occurs due to: --corrosion or scale on
material or wire - Water and/or grease on
material or wire -dirty or leaking
pistol/hose -wrong gas (should be CO2
with 20% Agon 8 litres/minute) I experienced with welding
the KSS that the half finished hull acts like a funnel. The created airstream
blows the gas away!. Good luck, Emile Van: owner- Frank and or all you
welding guru's Any tips on welding
sheet metal. I have my saddle tanks formed and I am going to weld two pieces
together. In my past experience I
have found it difficult. Pourous welds etc. One thought I had was to
weld em for strength and then Braze over the top. I will be welding
18 gauge cold rolled with a MIG Dean Get a
jump start on your taxes. Find
a tax professional in your neighborhood today. No virus found in this incoming message. |