|
Hi Vance,
Yes it is confusing! The picture of the Window on
the projects page does look like that. That is the shape as it came out of the
oven after forming and was taken by Greg prior to his machining it.
Hope that clarifies it. By the way, you are not the
first one who asked a similar question!
Best regards,
Jim K
----- Original Message -----
Sent: Wednesday, February 11, 2009 12:58
PM
Subject: Re: [PSUBS-MAILIST] port
question
Jim,
What I'm seeing on your web page looks like an
inclusive angle. Doesn't it take a conical frustrum to mount? If so, then the
question I'm asking is about the angle as measured from the inner wall radius
point. Or do my eyes decieve me entirely?
Vance
-----Original
Message-----
From: Jim Kocourek <kocpnt@tds.net>
To: personal_submersibles@psubs.org
Sent:
Wed, 11 Feb 2009 9:43 am
Subject: Re: [PSUBS-MAILIST] port question
Hi Vance,
The front viewport is 38 inches in diameter. The
mating surface is two 90 degree surfaces. That would a flat base with an OD
surface at 90 degrees.
I can hardly wait to install it, but it will be
one of the very last things as it is a great way to get things in and
out!
Best Regards,
Jim
----- Original Message -----
Sent: Wednesday, February 11, 2009 7:42
AM
Subject: [PSUBS-MAILIST] port
question
Jim,
What's the radius on that front viewport? Cone angle
for the mating surface?
Vance
|