|
Hi Dan H,
Thanks again for the tip on using pressure washer
for pressure testing. I only have completed testing one so far, but at 1,200 PSI
no pinholes and no endcaps blowing off.
I did have some leakage at the threads, but they
are deformed from welding and I have not finished taping them because I wish to
coat the inside with epoxy prior to getting cutting oil contamination on the
inside surfaces.
I did have one funny screw-up. I for got to put a
blow-off valve to relieve the pressure so I guess I'll have to carefully
partially loosen a fitting and allow it to bleed down as the quick couplers will
not uncouple with pressure inside.
Best Regards,
Jim K
|