Hi Frank, Can I make a suggestion that you use a 1-1/2” ball valve as you
get the seals, the housing, etc and a stainless steel ball with the hole
already through it along with seal kits etc already rated. All you have to do
is take the stem out and throw it away. We make ball valves and get our balls
from Taiwan. However there are now very cheap Italian ball valves and even
plastic ones which are good to 250 psi. Just a suggestion. Chs Hugh Hugh Fulton. Managing Director Tel : +64 9 5276055 Mobile: 021 680 174 hfulton@eclipsevalves.com ........................................................................... Eclipse Valves Ltd. www.eclipsevalves.com PO Box 18367, Glen Innes, Auckland 1743, NZ. Tel: +64 9 527 6135. Fax: +64 9 527 4532. ........................................................................... The information contained in this email is privileged and
confidential and is intended for the addressee only. If you are not the intended receipt you are asked to respect the
confidentiality and to not disclose or make use of its contents. If you have received in error please destroy or
contact the sender immediately. From:
owner-personal_submersibles@psubs.org
[mailto:owner-personal_submersibles@psubs.org] On Behalf Of ShellyDalg@aol.com Hi Vance. I did a little sketch while pondering how it would work.
Here's a picture. If you're making one, I want one too. Let me know if there's
anything I can do to help. Already got arthritis, so that's no problem. Frank D.
It's only a deal if it's where you
want to go. Find your travel deal here.
__________ Information from ESET NOD32 Antivirus, version of virus signature database 3368 (20080819) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com |