I had my K-250 dome annealed by Greg Cottrell and also had the retaining
ring (hatch) powder coated. He suggested I use Sikaflex-295 UV as the
sealant/adhesive between the dome and ring and the following instructions were
from an email to me that he said I could share.
"The 3 items should be 226 cleaner (window and seat), then 209 primer
(window and seat), then 295UV adhesive (a big fat bead in the corner of the
seat). It's a good idea to use a few small 1/16 rubber
shims between the window and seat so the adhesive doesn't all squeeze out.
I usually mask off the window with two half circles of vinyl mask (from the
local sign shop) to keep adhesive off the viewing area. You can wipe off
the excess around the window while it is soft and pull the vinyl off later. Some
guys let the excess harden and then cut it off later with a knife- this is a bad
idea because it scores the acrylic and can cause it to break under pressure.
Scratches/ cuts on the inside are not good."
The Items he is referring to are all Sika products. The process went
smoothly I used small pieces of 1/16 inch o-rings as my shims.
Kyle |