|
I'm no FEM expert but an engineer where I work is.
He is working on ANSYS also.
I'll ask him next week if he would answer your
questions.
Pierre
P.S. Those engineers, always usefull to have some
around... :)
----- Original Message -----
Sent: Thursday, July 12, 2007 1:16
PM
Subject: [PSUBS-MAILIST] ANSYS
SOFTWARE
Hi
When performing FEM analyzes on the pressure hull I set different
pressures to see what the hull can take. But the results are varying a great
deal all after which supports I use in these analyzes.
Is there any expert users on ANSYS in here, who can help me set the right
supports? I use ANSYS 10.0 -- Best Regards Øystein Skarholm www.ubat.no
|