[PSUBS-MAILIST]

["George Slaterpryce" <gslaterp@hotmail.com>]

I was attempting to machine the pieces for a metal "bobber" for my new soft 
ballast tank's water level indicator (Foam just gives at depth, so that's no 
good). The piece is essentially one piece 1cm in diameter 1mm thick walls 
and 1cm in length and another 5mm 1mm thick wall and 1cm in length tube with 
two 1cm diameter 1mm thick "washer" end caps with a center bore hole of 5mm.

I can get the pieces machine out great, that's the easy part. I'm trying to 
weld them all together however and I end up with some really shitty looking 
welds. I've never attempted to weld something so "delicate" before. What I'm 
trying to make here is a preasure proof bobber and the end product should be 
something like a hollow bearing.

All my welding is done via stick arc welding.

Any suggestions? 



************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003.  Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.

If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
	removeme-personal_submersibles@psubs.org

Removal of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.

PSUBS.ORG
PO Box 311
Weare, NH  03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************