Joe,
I'm using the same type of system on my sub, I have a sitck and rudder
arrangement like on an airplane. I have foot pedals that contol opposing
side " ailerons" which turn in the opposite directions for banked turns.
The stick controls the rear rudder, which is a side to side motion on the stick,
and for accending or decending the stick is pushed forward ( for down) and back
( for up ). This is what I have been working on for the last few
weeks on my to scale mock up. Everything is pretty straight forward
linkage, however the side to side motion on the stick, for rudder control are
miter gears so I can change that motion perpendicularly. An on one of the
foot pedals I needed to use two meshing gears to reverse the motion with a
counter shaft, so I could get a better angle (leverage) on the pedal. All
these motions are turning thru hull shafts in a rotating manner.
Regards
Brian
----- Original Message -----
Sent: Thursday, December 01, 2005
08:43
Subject: [PSUBS-MAILIST] Dive Plane
Mechanical Linkages
Since my boat as designed is primarily a snorkel boat on the
tiny diesel, dynamic flow over dive planes is critical to control.
I have in mind a mechanical linkage system similar to aircraft
control surfaces with either a bell crank and pulley system or better yet a
pushrod and torque tube system.
Individual control of the bow and stern planes as in the WWII
boats is not really practical, so I am planning on an interconnection via
either a single lever or a side mounted wheel. Very simple stuff, no
hydraulics or electric motors.
I welcome comments and suggestions as every time I put
something out, my design is improved tremendously as a result of the
input.
Thanks
Joe
************************************************************************
************************************************************************
************************************************************************ The
personal submersibles mailing list complies with the US Federal CAN-SPAM Act
of 2003. Your email address appears in our database because either you, or
someone you know, requested you receive messages from our organization. If you
want to be removed from this mailing list simply click on the link below or
send a blank email message to: removeme-personal_submersibles@psubs.org
Removal of your email address from this mailing list occurs by an automated
process and should be complete within five minutes of our server receiving
your request. PSUBS.ORG PO Box 311 Weare, NH 03281 603-529-1100
************************************************************************
************************************************************************
************************************************************************
|