----- Original Message -----
Sent: Tuesday, October 11, 2005 5:03
AM
Subject: Re: [PSUBS-MAILIST] hard
balast
Rick,
Your question is kind of brief. I assume
you know the difference between hard and soft ballast tanks.
There really isn't much of a relationship at
all. Soft ballast is only used on the surface to lift the sub out of
the water, to gain adequate freeboard to enter and exit the sub without
flooding it. If you have air in the soft ballast tanks when diving, it
will compress and as you go deeper and so you get heavier the farther down
you go. Not a good thing if you ever plan to resurface.
Hard ballast, on the other hand, is as it
implies. A hard, pressure tight, tank that is used to set buoyancy for
diving the sub. Since it is hard, it doesn't matter how much
air or water it contains while diving. Your buoyancy won't
change in relation to your depth.
Your sub should have sufficient soft ballast to
lift the conning tower high enough out of the water for it to be safe to
open the hatch. Your hard tank should be of sufficient displacement to
allow you to make fine adjustments in buoyancy. There is no substitute
for the soft ballast. You have to calculate how much water you have to
displace to push enough of the conning tower to a sufficient
height. You must have enough.
On the other hand, having to little hard
ballast tank only means that you have to do a better job of guessing the
proper amount of fixed ballast (lead weights) to put in the sub before
starting your dive. The more soft tank, the more adjustment you have
before you have to add or remove lead weights. To much hard tank
requires to much air consumption if you need to blow some ballast at
depth. For starters, I'd consider about five gallons of hard
ballast.
Dan H.
----- Original Message -----
Sent: Monday, October 10, 2005 6:03
PM
Subject: [PSUBS-MAILIST] hard
balast
does anyone know the prop realtion between
soft balast hard balast and displacement?
thanks
rick miller